Cabot Semi-Transparent Deck & Siding Stain Gallon

• Lightly pigmented to accentuate wood grain
• Oil Based and Acrylic Water Based formulas available
• Water-repellent and UV protection
• Oil based formula is ideal for decks, siding and fences
• One coat application
• When properly applied won't crack, peel or blister
• Not intended for interior surfaces

Features

Cabot Semi-Transparent Stains are deep penetrating, linseed oil-based stains that beautify and protect exterior wood. These lightly pigmented stains enhance the natural beauty of the wood by allowing the grain, texture, and color variations within the wood to show through. Acrylic 1300 series combines penetrating properties of oil-based with easy soap-and-water clean-up of water-based finishes. Will provide long-lasting, vapor-permeable protection that beautifies and enriches exterior wood surfaces. Formulated with non-fade, earth tone pigments to weather slowly over time.

Coverage

Spread rates will vary depending on the porosity of the surface. On smooth surfaces, 0300 series covers approximately 450-650 square feet per gallon, 200-300 square feet per gallon on rough surfaces. 1300 and 16300 series cover approximately 200-300 square feet per gallon on smooth surfaces.

Where to Use

Cabot Semi-Transparent Oil Based Stains are for use on exterior wood decks, siding, fences, shingles and roofs. Acrylic water based stains are for use on exterior wood siding, shingles, shakes and roofs. They are especially effective on rough-sawn surfaces; and excellent results are obtained on premium grade lumber such as cedar, fir, pine, cypress, spruce, redwood and plywood panel siding.

Preparing Your Surfaces

Proper surface preparation is the key to maximum stain performance. The durability of this product can be impaired by an unsound or poorly prepared surface. It is very important that the surface be clean of all dirt, mildew stains, loose wood fibers and other foreign matter. In order to be effective, a stain must be able to penetrate. Surfaces must be structurally sound and absolutely dry. (Moisture content must be below 15%, or wood must be exposed to dry weather a minimum of 3 to 5 days.) Previously semi-transparent stained or weathered wood surfaces must be either sanded, scrubbed with a detergent solution or Cabot Problem-Solver® Wood Cleaner and a stiff bristle brush, or power washed to remove the surface layer of all loose wood fibers, dirt, mildew stains, chalky residue and other foreign matter. Use Cabot Problem-Solver Strippers (8004) to safely remove all stains and paints from wood surfaces. Use Cabot Problem-Solver Wood Brightener to easily remove nail and metal rust stains, and renew the wood's appearance. New smooth wood that is unseasoned or appears shiny should be allowed to weather sufficiently before staining, but generally no longer than three months.

Application

Stir thoroughly before and occasionally while using. Intermix all containers of the same color. For best results, use a high quality pad applicator or stain brush. If you must spray, always backbrush immediately after each section is coated to ensure uniformity. To avoid lap marks, always start at one edge and follow through to the end of the board. Restain depending on sun exposure and wear every 3-5 years (1 to 2 years for decks).

Cleanup and Disposal

Clean brushes and equipment with mineral spirits.